[Solved] When a train is rounding a curve to prevent side thrust on the wheel flanges of cars

Q.	When a train is rounding a curve to prevent side thrust on the wheel flanges of cars
A.	Opposite thrust is created to counter balance this thrust
B.	Guide rail sections are provided to take care of thrust
C.	Thrust eliminators are provided in the train
D.	Outside rails are realised
E.	Rail section is made thick on curvature
Answer» D. Outside rails are realised

777

Do you find this helpful?

View all MCQs in

Applied Mechanics

Discussion

No comments yet

Related MCQs

A locomotive of weight 100 tonnes is attached to train of wagons weighing 1000 tonnes. The locomotive pulls the wagons with a constant velocity of 36 km/hour. When the coupling between the train and wagons breaks, the wagons roll on 95 m in 10 sec. The distance between the locomotive and the wagons at this instant assuming that the forces acting on the train are unaltered would be
A train moving at 60 kilometers per hour is struck by a bullet moving 1000 m/sec at right angles to the train. The direction with which the bullet appears to strike the train would be
A train travels between two stations 15 km, apart in 18 minutes. If the train accelerates for a part of journey uniformly followed by uniform relardation, the maximum speed attained by the train, during, the journey, will be
A train travels between two stations 15 km apart in 18 minutes. If the train accelerates for a part of journey uniformly followed by uniform retardation, the maximum speed attained by the train during the journey will by
A grinding wheel is rotating at 3000 rpm. When the switch is turned off the wheel stops in 10 seconds. The uniform deceleration of the wheel was
In a single threaded worm and worm wheel the number of teeth on the worm wheel is 80. The diameter of the effort wheel is 12 cm and that of load drum is 8 cm. The velocity ratio will be
A grinding wheel rotates at 3000 rpm. When power supply is cut-off the wheel stops in 10 seconds. The number of revolutions made by the wheel before coming to rest would be
In a single threaded worm and worm wheel the number of teeth on the worm wheel is 60. The diameter of the effort wheel is 12 cm and that of load drum is 8 cm. The velocity ratio will be
A grinding wheel rotates at 3000 rpm. When power supply is cut off the wheel stops in 5 sec. The number of revolutions made by the wheel before coming to rest would be
The torque of 50 Nm is applied on the wheel operating a valve. If the wheel is rotated through two revolutions, work done in Newton-metres is given by