The edges of boiler plates for fullering and caulking are bevelled at an angle of

Related MCQs

• The edge of the plates for boilers and tanks are usually bevelled at an angle of 80?
• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
• A boiler shell 280 cm diameter and plate thickness 12 mm is subjected to an internal pressure of 1.2 MN/m2. The hoop stress will be
• The diameter of rivets for 20 mm thick plates would be
• The holes in plates for reveting are usually made by
• In the Laminated springs, the flat plates of different lengths are provided for
• For butt welding of two plates each of which is 25 mm thick, the best process would be
• For butt welding of two plates, each of which is 300 cm thick, the best process would be
• The maximum thickness of the plates used in pressed steel tanks is
• If during operation a boiler bursts, the matter should be reported to