The edge of the plates for boilers and tanks are usually bevelled at an angle of 80?

Related MCQs

• The edges of boiler plates for fullering and caulking are bevelled at an angle of
• The maximum thickness of the plates used in pressed steel tanks is
• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
• The holes in plates for reveting are usually made by
• The maximum size of the fillet weld that can be applied to the toe of an angle or the round edge should be
• In elevated circular steel tanks, conical bottoms are attached when
• The allowable stresses for the design of steel tanks are adopted
• In elevated circular steel tanks, hemispherical bottoms are preferred because
• Hydraulic testing of boilers is done at pressures
• Safety valve used on locomotive boilers is generally of