The maximum thickness of the plates used in pressed steel tanks is

Related MCQs

• The edge of the plates for boilers and tanks are usually bevelled at an angle of 80?
• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
• In elevated circular steel tanks, conical bottoms are attached when
• The allowable stresses for the design of steel tanks are adopted
• In elevated circular steel tanks, hemispherical bottoms are preferred because
• A compressed air cylinder carries approximately 70 kg/cm2 pressure at the time of delivery. The inside diameter is 25 cm. If the steel has a yield point of 2300 kg/sq cm and a safety factor of 2.5 the wall thickness should be
• The minimum thickness of steel members exposed to weather and accessible for paintng is
• The minimum thickness of steel members exposed to weather and accessible for painting is
• In a central heating system, the seamless copper tubing used has an inside diameter of 20 mm and a wall thickness of 0.6 mm. For a maximum pressure of 1750 Kpa, when allowable stress is 225 Mpa, the safety factor will be
• What should be the thickness of a cast iron pipe 45 cm diameter if it is required to sustain 6 kg/sq cm inside pressure ? The maximum stress in the pipe material being limited to 140 kg/cm2