For butt welding of two plates, each of which is 300 cm thick, the best process would be

Related MCQs

• For butt welding of two plates each of which is 25 mm thick, the best process would be
• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
• The diameter of rivets for 20 mm thick plates would be
• When properly made, a butt weld has the strength equal to
• In case of quadruple riveted butt joints the joint efficiency is usually assumed in the range
• In a butt welded joint, the size of weld is
• In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
• The uniform rate of descent is maintained by a brake on the drum which applies the necessary torque of 300 kg-m what additional brake torque is required to bring the system to rest in 0.50 second?
• A single ply leather belt running at a belt velocity of 300 ft/min is likely to transmit per inch of width
• The edges of boiler plates for fullering and caulking are bevelled at an angle of