In elevated circular steel tanks, conical bottoms are attached when

Related MCQs

• In elevated circular steel tanks, hemispherical bottoms are preferred because
• The allowable stresses for the design of steel tanks are adopted
• The maximum thickness of the plates used in pressed steel tanks is
• A foundation bolt with a circular end is secured to the floor by means of a steel cotter. If the pull on the bolt is 14000 kg, the diameter of the bolt should be
• The edge of the plates for boilers and tanks are usually bevelled at an angle of 80?
• A unknown weight falls through 1 cm on a collar rigidly attached to the lower end of a vartical bar 3 cm long and 6 cm2 in section. If the maximum instantaneous extension is 2 mm the value of stress would be
• The ratio of maximum shear stress to average shear stress for a circular section is
• For a circular section the ratio of the plastic moment capacity to the yield moment capacity is
• The segmental bottom of a circular tank is subjected to
• The ratio of the area of cross-section of a circular section and the area of its core is