Dead weight type safety valve is not used on locomotives because

Related MCQs

• Safety valve used on locomotive boilers is generally of
• According to Indian Boiler Regulations the essential requirement of any safety valve is that
• The blow off pressure of a safety valve is
• In a central heating system, the seamless copper tubing used has an inside diameter of 20 mm and a wall thickness of 0.6 mm. For a maximum pressure of 1750 Kpa, when allowable stress is 225 Mpa, the safety factor will be
• In a steam engine, the valve rod is connected to an eccentric rod by means of
• A compressed air cylinder carries approximately 70 kg/cm2 pressure at the time of delivery. The inside diameter is 25 cm. If the steel has a yield point of 2300 kg/sq cm and a safety factor of 2.5 the wall thickness should be
• The value of load factor which accounts for margin of safety in plastic design for gravity loads is about
• The trunions of a mixing machine have an effective length of 30 cm and the weight coming on each trunion is 1250 kg. If the fibre stress is not to exceed 350 kg/sq-cm the diameter of the trunions should be
• A unknown weight falls through 1 cm on a collar rigidly attached to the lower end of a vartical bar 3 cm long and 6 cm2 in section. If the maximum instantaneous extension is 2 mm the value of stress would be
• A solid shaft and a hollow shaft are to be of equal strength in torsion. The hollow shaft is to be 10% larger in diameter than the solid shaft. The ratio of the weight of the hollow shaft will be (both shafts being made of same material)