The blow off pressure of a safety valve is

Related MCQs

• Dead weight type safety valve is not used on locomotives because
• According to Indian Boiler Regulations the essential requirement of any safety valve is that
• Safety valve used on locomotive boilers is generally of
• In a central heating system, the seamless copper tubing used has an inside diameter of 20 mm and a wall thickness of 0.6 mm. For a maximum pressure of 1750 Kpa, when allowable stress is 225 Mpa, the safety factor will be
• A compressed air cylinder carries approximately 70 kg/cm2 pressure at the time of delivery. The inside diameter is 25 cm. If the steel has a yield point of 2300 kg/sq cm and a safety factor of 2.5 the wall thickness should be
• In a steam engine, the valve rod is connected to an eccentric rod by means of
• In case of pressure vessels having open ends the fluid pressure induces
• The value of load factor which accounts for margin of safety in plastic design for gravity loads is about
• A thin cylinder contains fluid at a pressure of 30 kg kg/cm2, the internal diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have a minimum wall thickness of
• In order to avoid interference for 20 pressure and teeth, minimum number of teeth should be