When both pinion and gear are made of the same material, then from the design point of view

Related MCQs

• The loading on a pinion gear is usually
• The pressure angle an involute gear profile gear
• In above problem the cone pitch angle of the pinion will be
• A pair of straight tooth bevel gears connects a pair of shafts at 90?. The velocity ratio is 3:1. The cone ptich angle of the pinion will be
• A solid shaft and a hollow shaft are to be of equal strength in torsion. The hollow shaft is to be 10% larger in diameter than the solid shaft. The ratio of the weight of the hollow shaft will be (both shafts being made of same material)
• In gear design, addendum is equal to
• For design purpose a spur gear tooth is considered
• A key and a shaft are made from the same material. The key is rectangular with a width of D/4 and a height of 3D/16. The shaft is under torsion only. The necessary length of the key for equal strength of the shaft and key will be
• The surface endurance limit of gear material is dependent on its
• For which of the following gear material the noise level is relatively low?