In case of a cotter joint the compressive load is transmitted from one rod to another rod

Related MCQs

• In a cotter joint in order to ensure that cotter does not work back
• A foundation bolt with a circular end is secured to the floor by means of a steel cotter. If the pull on the bolt is 14000 kg, the diameter of the bolt should be
• In a steam engine, the valve rod is connected to an eccentric rod by means of
• As per Indian Boilers regulations the type of joint preferred for longitudinal joint is
• In case of quadruple riveted butt joints the joint efficiency is usually assumed in the range
• In case of a knuckle joint the pin is likely to fail in
• Lowest value of joint efficiency is assumed in case of
• A spring deflects 50 mm under a 250 kg load. If the load is applied gradually, the energy absorbed by the spring will be
• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
• A cantilever beam of square section is subjected to a load W at the free end. If the length of the beam is increased and load reduced to half the deflection at the free end as compared to original deflection would be