By using large thread angles in lifting machine

Related MCQs

• The cross-section of a standard fillet weld is a triangle with base angles of
• In a standard coarse thread bolt the stress concentration is maximum at
• On a triple thread screw
• In a tap set, the first tap used in thread cutting is
• The crest diameter of a screw thread is same as
• Transverse slots are provided on a thread
• Screw parts with a right hand thread must only be stressed
• Fine thread with 16 mm nominal diameter and 1.5 mm pitch is designed as
• If machine number is loaded in such a way that the three principla stresses at a point are 600 kg/cm2 compression. 800 kg/cm2 tension and zero. The maximum shear stress at the point will be
• In most machine members, the damping capacity of the material should be