Large sections usually have a somewhat lower permissible stress than small sections. This is due to

Related MCQs

• In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
• Approximate horse power that can be transmitted by a shaft 60 mm diameter at 180 r.p.m. with permissible shear stress of 850 kg/cm2, would be
• A spherical metal vessel 120 cm diameter is subjected to an internal pressure of 15 kg/sq cm. If the permissible stress is 625 kg/sq cm and the efficiency of the riveted joints is 75%, the required thickness of the plate would be
• A spherical gas tank is made of 1 cm steel plate hemispheres but welded together. The tank is 1503 cm in diameter. The allowable internal pressure to which tank may be subjected is the permissible stress be limited to 840 kg/sq cm would be in the range
• A unknown weight falls through 1 cm on a collar rigidly attached to the lower end of a vartical bar 3 cm long and 6 cm2 in section. If the maximum instantaneous extension is 2 mm the value of stress would be
• In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at
• The ratio of maximum shear stress to average shear stress for a circular section is
• If the shearing stress in a nut is equal to half the tensile stress in a bolt then the length of nut should be equal to
• With a punch for which the maximum crushing stress is 4 times the maximum shearing stress of the plate, the biggest hole that can be punched in the plate would be of diameter equal to
• When large quantities of bolts are to be purchased the quantity is usually specified in terms of