With a punch for which the maximum crushing stress is 4 times the maximum shearing stress of the plate, the biggest hole that can be punched in the plate would be of diameter equal to

Related MCQs

• If the shearing stress in a nut is equal to half the tensile stress in a bolt then the length of nut should be equal to
• A spherical gas tank is made of 1 cm steel plate hemispheres but welded together. The tank is 1503 cm in diameter. The allowable internal pressure to which tank may be subjected is the permissible stress be limited to 840 kg/sq cm would be in the range
• A spherical metal vessel 120 cm diameter is subjected to an internal pressure of 15 kg/sq cm. If the permissible stress is 625 kg/sq cm and the efficiency of the riveted joints is 75%, the required thickness of the plate would be
• In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
• A boiler shell 280 cm diameter and plate thickness 12 mm is subjected to an internal pressure of 1.2 MN/m2. The hoop stress will be
• Approximate horse power that can be transmitted by a shaft 60 mm diameter at 180 r.p.m. with permissible shear stress of 850 kg/cm2, would be
• The stress concentration factor for flat bar in tension with a circular hole, is
• In a central heating system, the seamless copper tubing used has an inside diameter of 20 mm and a wall thickness of 0.6 mm. For a maximum pressure of 1750 Kpa, when allowable stress is 225 Mpa, the safety factor will be
• What should be the thickness of a cast iron pipe 45 cm diameter if it is required to sustain 6 kg/sq cm inside pressure ? The maximum stress in the pipe material being limited to 140 kg/cm2
• In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at