If the Brinell hardness number of a sample of steel is 200, the ultimate tensile strength will be approximately

Related MCQs

• A steel specified as St 50 will have a tensile strength of approximately
• Which of the following is not a standard ball diameter for Brinell hardness testing?
• For steel ultimate strength in tension compared to that in shear is
• The ultimate strength design of steel structures makes use of
• In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at
• A compressed air cylinder carries approximately 70 kg/cm2 pressure at the time of delivery. The inside diameter is 25 cm. If the steel has a yield point of 2300 kg/sq cm and a safety factor of 2.5 the wall thickness should be
• The loss of strength in compression which occurs when there is a gain in strength in the tension due to overloading is
• The surface hardness that can be obtained by nitriding is generally in the range
• The bursting pressure of 12 mm ID, 14 mm OD seamless cartridge brass tubing having ultimate whear stress of 225 Mpa, will be nearly
• A thin cylinder contains fluid at a pressure of 30 kg kg/cm2, the internal diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have a minimum wall thickness of