The conversion from parallel to serial data transmission and vice versa takes place inside the interface circuits.

Related MCQs

• The side of the interface circuits, that has the data path and the control signals to transfer data between interface and device is            
• USB is a parallel mode of transmission of data and this enables for the fast speeds of data transfers.
• In a serial port interface, the INTR line is connected to            
• The transformation between the Parallel and serial ports is done with the help of               
• The Interface circuits generate the appropriate timing signals required by the BUS control scheme.
• In a 32 bit processor, the A0 bit of the address line is connected to            of the parallel port interface.
• In the output interface of the parallel port, along with the valid signal                is also sent.
• In a general 8-bit parallel interface, the INTR line is connected to                 
• The serial port is used to connect basically            and processor.
• The standard used in serial ports to facilitate communication is