[Solved] The transient response of a solid can be determined by the equation. (Where, P is density, V is volume, c is specific heat and A is area)

Q.	The transient response of a solid can be determined by the equation. (Where, P is density, V is volume, c is specific heat and A is area)
A.	– 4 p v c = h a (t – t0)
B.	– 3 p v c = h a (t – t0)
C.	– 2 p v c = h a (t – t0)
D.	– p v c = h a (t – t0)
Answer» D. – p v c = h a (t – t0)
Explanation: it can be determined by relating rate of change of internal energy with conductive heat exchange at the surface.

882

Do you find this helpful?

View all MCQs in

Engineering Physics

Discussion

No comments yet

Related MCQs

A large heat exchanger transfers a total of 100 MW. Assume the wall separating steam and seawater is 4 mm of steel, conductivity 15 W/m K and that a maximum of 5°C difference between the two fluids is allowed. Find the required minimum area for the heat transfer.
A small light bulb (25 W) inside a refrigerator is kept on and 50 W of energy from the outside seeps into the refrigerated space. How much of temperature difference to the ambient(at 20°C) must the refrigerator have in its heat exchanger having an area of 1 m2 and heat transfer coefficient of 15 W/Km2 to reject the leak of energy.
The specific heat of the substance is defined as the amount of heat required to raise a unit mass of the substance through a unit rise in temperature.
The black grille on the back of a refrigerator has a surface temperature of 35°C with a surface area of 1 m2. Heat transfer to the room air at 20°C takes place with convective heat transfer coefficient of 15 W/Km^2. How much energy is removed during 15 minutes of operation?
catchment area is a sum of free catchment area and intercepted catchment area.
A composite wall is made of two layers of thickness δ1 and δ2 having thermal conductivities k and 2k and equal surface area normal to the direction of heat flow. The outer surface of composite wall are at 100 degree Celsius and 200 degree Celsius. The minimum surface temperature at the junction is 150 degree Celsius. What will be the ratio of wall thickness?
Transient condition means
Which of the following is not correct in a transient flow process?
A water-heater is covered with insulation boards over a total surface area of 3 m2. The inside board surface is at 75°C and the outside being at 20°C and the conductivity of material being 0.08 W/m K. Find the thickness of board to limit the heat transfer loss to 200 W ?
As the car slows down, the brake shoe and steel drum continuously absorbs 25 W. Assume a total outside surface area of 0.1 m2 with a convective heat transfer coefficient of 10 W/Km2 to the air at 20°C. How hot does the outside brake and drum surface become when steady conditions are reached?