- Civil Engineering
- Design of Steel Structures
- Factor of safety is the ratio of

Q. |
## Factor of safety is the ratio of |

A. | yield stress to working stress |

B. | tensile stress to working stress |

C. | compressive stress to working stress |

D. | bearing stress to working stress |

Answer» A. yield stress to working stress |

View all MCQs in:
Design of Steel Structures

- P E to be 25% of the computed value of P and E respectively, the minimum value of the factor of safety is
- Other conditions being same, the load factor in indeterminate structures is
- For eccentrically loaded columns, the bending factor is
- Shape factor is a property which depends
- The shape factor of an isosceles triangle for bending about the axis parallel to the base is:
- In case of timber structures, the form factor for solid circular cross-section is taken as
- Load factor is
- If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as
- In plastic analysis, the shape factor for circular sections, is
- As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements

Login to Continue

It will take less than 2 minutes

Report MCQ