- Civil Engineering
- Design of Steel Structures
- The centrifugal force due to curvature o...

Q. |
## The centrifugal force due to curvature of track is assumed to act on the bridge at a height of |

A. | 1.23 m above the rail level |

B. | 1.50 m above the rail level |

C. | 1.83 m above the rail level |

D. | 2.13 m above the rail level |

Answer» C. 1.83 m above the rail level |

View all MCQs in:
Design of Steel Structures

- The centrifugal force due to curvature of track is assumed to act on the bridge at a height of
- The load on a lintel is assumed as uniformly distributed if the height of the masonry above it, is upto a height of
- The load on a lintel is assumed as uniformly distributed if the height of the masonry above it, is upto a height of
- If the floor is supported at or near the bottom but top chords of a bridge is not braced, then the bridge is called
- If the floor is supported at or near the bottom but top chords of a bridge is not braced, then the bridge is called
- If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as
- If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as
- Compression force in two end posts, the pin of a rocker bearing in a bridge is designed for
- The moment-curvature relation at a plastic hinge is
- The portal bracing in a truss bridge is used to

Login to Continue

It will take less than 2 minutes

Report MCQ