The load on a lintel is assumed as uniformly distributed if the height of the masonry above it, is upto a height of

Related MCQs

• The load on a lintel is assumed as uniformly distributed if the height of the masonry above it, is upto a height of
• As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
• The centrifugal force due to curvature of track is assumed to act on the bridge at a height of
• The centrifugal force due to curvature of track is assumed to act on the bridge at a height of
• The beam outside a wall upto floor level above it, is known as
• In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate
• In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate
• The basic wind speed is specified at a height 'h' above mean ground level in an open terrain. The value of 'h' is
• The slenderness ratio of a column supported throughout its length by a masonry wall is
• The slenderness ratio of a column supported throughout its length by a masonry wall is