- Civil Engineering
- Design of Steel Structures
- The allowable stress in axial tension is...

Q. |
## The allowable stress in axial tension is generally kept less if thickness of the member is more than |

A. | 10 mm |

B. | 12 mm |

C. | 15 mm |

D. | 20 mm |

Answer» D. 20 mm |

View all MCQs in:
Design of Steel Structures

- The allowable stress in axial tension is generally kept less if thickness of the member is more than
- The equivalent axial tensile load Pe, which produces an average axial tensile stress in the section equivalent to the combined stress due to axial tension P and bending M, at the extreme fibre of the section, is given by (where Z is the section modulus of the section).
- The allowable stress in axial tension for rolled I-sections and channels, is taken as
- An axial loaded column is supported on a slab base whose projection is 8 cm. If the intensity of pressure from concrete is 40 kg/cm2 and allowable bending stress in slab base is 1890 kg/cm2 , the thickness (t) of the slab base, is
- If is the maximum allowable bending stress in a tension member whose radius of gyration is and depth is 2y, the required cross sectional area is given by
- If is the maximum allowable bending stress in a tension member whose radius of gyration is and depth is 2y, the required cross sectional area is given by
- In a tension member if one or more than one rivet holes are off the line, the failure of the member depends upon:
- In a tension member if one or more than one rivet holes are off the line, the failure of the member depends upon:
- A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed
- A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed

Login to Continue

It will take less than 2 minutes

Report MCQ