During forward blocking state of SCR, the voltage and current respectively are

Related MCQs

• When an SCR is in forward blocking mode, the applied voltage
• A single-phase voltage controller, using one SCR in anti parallel with a diode, feeds a load R and Vs = 230 V. For a firing angel of 90° for the SCR, the PMMC voltage connected across R would read
• During forward blocking state, a thyristor is associated with:
• In a single phase full wave rectifier, during blocking state the peak inverse voltage of diode is
• A forward voltage can be applied to an SCR after its:
• A single phase voltage controller has input of 230 V and a load of 15 Ω resistive. For 6 cycles on and 4 cycles off, determine the average value of SCR current.
• Once SCR starts conducting a forward current, its gate losses control over:
• An SCR is triggered at 40° in the positive half cycle only. The average anode current is 50 A. If the firing angle is changed to 80°, the average anode current is likely to be
• If the gate voltage of an SCR is removed, then the
• A thyristor has its gate current zero. To start conduction the forward voltage must exceed