When an SCR is in forward blocking mode, the applied voltage

Related MCQs

• During forward blocking state of SCR, the voltage and current respectively are
• A single-phase voltage controller, using one SCR in anti parallel with a diode, feeds a load R and Vs = 230 V. For a firing angel of 90° for the SCR, the PMMC voltage connected across R would read
• A forward voltage can be applied to an SCR after its:
• During forward blocking state, a thyristor is associated with:
• In a single phase full wave rectifier, during blocking state the peak inverse voltage of diode is
• Once SCR starts conducting a forward current, its gate losses control over:
• If the gate voltage of an SCR is removed, then the
• A single phase voltage controller has input of 230 V and a load of 15 Ω resistive. For 6 cycles on and 4 cycles off, determine the average value of SCR current.
• A thyristor has its gate current zero. To start conduction the forward voltage must exceed
• In a thyristor, the forward breakover voltage