A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = Vm sin ωt. The thyristor will conduct

Related MCQs

• A single phase half wave converter is feeding a resistive load. Just before triggering, the voltage across thyristor is
• A single-phase half-wave thyristor circuit with R load is triggered at an angle of α = 0°. As such, the maximum value of the average output voltage would be given by Consider Vs = Vm sinωt.
• In a full wave converter (M - 2 connection) feeding an RLE load, the peak thyristor current is 15 A. For fully controlled bridge circuit and same load current, the peak thyristor current will be
• A single phase half wave rectifier is feeding a resistive load. When a = 0, dc output voltage is 127 V. When a = 30°, the dc output voltage will be about
• In a single phase half-wave thyristor circuit with R load & Vs=Vm sinωt, the maximum value of the load current can be given by
• A single phase step up cycloconverter changes 50 Hz to 100 Hz. Then one half wave of input will give rise to
• In a 3 phase full wave regulator feeding a star connected resistance load the input voltage is 400 V line to line. The firing angle is 160°. The line to line output voltage would be
• Cuk-converter is better than Buck converter in terms of the output voltage.
• In a 3 phase full converter the average load current is 150 A. The average thyristor current is
• In a 3 phase half wave rectifier, when firing angle is less than 90 degree, then the average dc output voltage becomes