A single phase half wave rectifier is feeding a resistive load. When a = 0, dc output voltage is 127 V. When a = 30°, the dc output voltage will be about

Related MCQs

• A single phase half wave converter is feeding a resistive load. Just before triggering, the voltage across thyristor is
• In a single phase full wave regulator feeding a resistive load, the average current over one full cycle
• In a fully controlled bridge converter feeding a resistive load the waveshapes of output voltage and output current
• In a 3 phase full wave regulator feeding a star connected resistance load the input voltage is 400 V line to line. The firing angle is 160°. The line to line output voltage would be
• A single phase half wave controlled rectifier circuit has an R-L load. A freewheeling diode is also in the circuit. When freewheeling diode is conducting the SCR
• A full wave rectifier with resistive load produces
• In a 3 phase half wave rectifier, when firing angle is less than 90 degree, then the average dc output voltage becomes
• A single-phase half-wave thyristor circuit with R load is triggered at an angle of α = 0°. As such, the maximum value of the average output voltage would be given by Consider Vs = Vm sinωt.
• A single phase voltage controller has input of 230 V and a load of 15 Ω resistive. For 6 cycles on and 4 cycles off, determine the average value of SCR current.
• In a single phase half-wave thyristor circuit with R load & Vs=Vm sinωt, the maximum value of the load current can be given by