A single phase half wave converter is feeding a resistive load. Just before triggering, the voltage across thyristor is

Related MCQs

• A single phase half wave rectifier is feeding a resistive load. When a = 0, dc output voltage is 127 V. When a = 30°, the dc output voltage will be about
• A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = Vm sin ωt. The thyristor will conduct
• In a full wave converter (M - 2 connection) feeding an RLE load, the peak thyristor current is 15 A. For fully controlled bridge circuit and same load current, the peak thyristor current will be
• In a single phase full wave regulator feeding a resistive load, the average current over one full cycle
• In a fully controlled bridge converter feeding a resistive load the waveshapes of output voltage and output current
• A single-phase half-wave thyristor circuit with R load is triggered at an angle of α = 0°. As such, the maximum value of the average output voltage would be given by Consider Vs = Vm sinωt.
• In a single phase half-wave thyristor circuit with R load & Vs=Vm sinωt, the maximum value of the load current can be given by
• In a 3 phase full wave regulator feeding a star connected resistance load the input voltage is 400 V line to line. The firing angle is 160°. The line to line output voltage would be
• A single phase voltage controller has input of 230 V and a load of 15 Ω resistive. For 6 cycles on and 4 cycles off, determine the average value of SCR current.
• A single-phase voltage controller, using one SCR in anti parallel with a diode, feeds a load R and Vs = 230 V. For a firing angel of 90° for the SCR, the PMMC voltage connected across R would read