McqMate

Q. |
## Minimum pitch of the rivets shall not be less than (Where d is gross diameter of rivet) |

A. | 1.5 d |

B. | 2.0 d |

C. | 2.5 d |

D. | 3.0 d |

Answer» C. 2.5 d |

1.5k

0

Do you find this helpful?

10

View all MCQs in

Design of Steel StructuresNo comments yet

- The distance measured along one rivet line from the centre of a rivet to the centre of adjoining rivet on an adjacent parallel rivet line, is called
- The distance measured along one rivet line from the centre of a rivet to the centre of adjoining rivet on an adjacent parallel rivet line, is called
- The minimum pitch of rivet holes of diameter d should not be less than
- Diameter of a rivet hole is made larger than the diameter of the rivet by
- In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the gross-diameter of the rivet is 26 mm, the number of rivets required in the splice, is
- In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the gross-diameter of the rivet is 26 mm, the number of rivets required in the splice, is
- The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is
- The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is
- When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which moment in any rivet.)
- If p and d are pitch and gross diameter of rivets, the efficiency ( ) of the riveted joint, is given by