The effect of racking forces is considered in the design of
(i) Lateral braces
(ii) Chord members
The correct answer is

Related MCQs

• Study the following statements. (i) Top lateral bracing prevents the sides-way buckling of the chord. (ii) Sway bracing keeps the rectangular shape of the bridge cross-section. (iii) Sway bracing transfers the load from top of end posts to bearings. The correct answer is
• As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
• The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is
• The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is
• Battening is preferable when the (i) Column carries axial load only (ii) Space between the two main components is not very large (iii) Column is eccentrically loaded The correct answer is
• Bearing stiffeners are provided at (i) The supports (ii) The mid span (iii) The point of application of concentrated loads The correct answer is
• The most commonly used sections in lateral system to carry shear force in built up columns, are
• The effective length of a simply supported beam with ends restrained against torsion, and also the ends of compression flange partially restrained against lateral bending, is given by
• The most commonly used sections in lateral system to carry shear force in built up columns, are
• The effective length of a simply supported beam with ends restrained against torsion, and also the ends of compression flange partially restrained against lateral bending, is given by