A simply supported beam carrying a central load, will be safe in deflection if the ratio of its span to depth, is

Related MCQs

• A simply supported beam carrying a central load, will be safe in deflection if the ratio of its span to depth, is
• As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
• The central deflection of a simply supported steel beam of length L with a concentrated load W at the centre, is
• The central deflection of a simply supported steel beam of length L with a concentrated load W at the centre, is
• If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is
• For simply supported beams, the maximum permitted deflection, is
• The effective length of a simply supported beam with ends restrained against torsion, and also the ends of compression flange partially restrained against lateral bending, is given by
• The effective length of a simply supported beam with ends restrained against torsion, and also the ends of compression flange partially restrained against lateral bending, is given by
• If R is the reaction on the bearing plate, the minimum moment of. inertia of the bearing stiffener provided at the support of a plate girder of overall depth D, the maximum thickness of the compression flange T, carrying total load W, is
• In case of cantilever fillers, the ratio of the span L to depth d, should not exceed