If R is the reaction on the bearing plate, the minimum moment of. inertia of the bearing stiffener provided at the support of a plate girder of overall depth D, the maximum thickness of the compression flange T, carrying total load W, is

Related Questions

• When the depth of a plate girder is at least times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if is
• When the depth of a plate girder is at least times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if is
• As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
• Modified moment of inertia of sections with a single web, is equal to moment of inertia of the section about Y-Y axis at the point of maximum bending moment and is multiplied by the ratio of
• The thickness of the web of a mild steel plate girder is less than d/200. If only one horizontal stiffener is used, it is placed at
• The thickness of the web of a mild steel plate girder is less than d/200. If only one horizontal stiffener is used, it is placed at
• Bearing stiffener in a plate girder is used to
• Bearing stiffener in a plate girder is used to
• Horizontal stiffener in a plate girder is provided to safeguard against
• If W and L are the total superimposed load and the span of a plate girder in metres, the approximate self weight (W) of the girder, is taken as