in compression test, the top and bottom faces of the specimen on which load is applied should be               

Related MCQs

• in type of bend test, specimen is held at two points and load is applied at the center
• a compression test specimen has                         cross section
• tensile test was conducted on a steel specimen of diameter 20 mm and gauge length 75 mm. the gauge length and diameter during fracture are 95 mm and 12 mm respectively. If load at upper yield point is 500 kg, the upper yield stress is
• tensile test was conducted on a steel specimen of diameter 20 mm and gauge length 75 mm. the gauge length and diameter during fracture are 95 mm and 12 mm respectively. If ultimate tensile load is 8000 kg, the UTS is                     
• tensile test was conducted on a steel specimen of diameter 20 mm and gauge length 75 mm. the gauge length and diameter during fracture are 95 mm and 12 mm respectively. Its elongation is
• during the tensile test, the length of specimen and its cross section area
• a steel specimen during the test subjected to a stress of 300 N/mm2 and strain 1.5 x 10-3. the modulus of elasticity of steel is
• A tensile test specimen has cross section
• for measuring the elongation of specimen on UTM during tensile test is used
• an aluminium tensile test specimen has reduction area of 44%. Its true strain is