The tensile force at a distance y from support in a vertical hanging bar of length L whch carries a load P at the bottom is equal to---- where w = weight per unit length

Related MCQs

• A simply supported beam 'A' of length l, breadth b and depth d carries a central load W. Another beam 'B' of the same dimensions carries a central load equal to 2 W. The deflection of beam 'B' will be
• Two cantilever beams are of equal length. One carries a uniformly distributed load and other carries same load but concentrated at the free end. The ratio of maximum deflection is
• A beam of overall length 1 with equal overhangs on both sides carries a uniformly distributed load over the entire length. To have numerically equal bending moments at centre of the beam and at supports, the distance between the supports should be
• A stepped bar of steel consists of a pmormtion with cross section area 500 mm2 connected to a portion with cross section area 1000 2. Each portion has a length of 1 m. The modulus of elasticity of steel is 200 GPa. The maximum elongation of the bar by applying an axial tensile force at the ends without exceeding a stress of 100 MPa is    mm.
• A bar of length L metres extends by l mm under a tensile force of P. The strain produced in the bar is
• A cantilever beam of length / carries a gradually varying load from zero at free end and w per unit length at the fixed end. The maximum deflection oes at
• The deformation of a steel bar under its own weight as compared to the deformation caused by a direct load equal to the weight of the shaft will be
• A strip of steel (E = 200 GPa, 0.25) has a length of 1 m, width of 200 mm and thickness of 10 mm. A line of length 1 m is drawn parallel to its length on one of its side surfaces. When the strip is subjected to an axial tensile force of 100 kN, the length of the line will be                  mm.
• In a simply supported beam of span 3 mts., a point load of 60 kN acts at a distance of 1 mt. from left support, the shear force at 1 mt. from rt. Support is
• A prismatic bar of volume V is subjected to a tensile force in longitudinal direction. If Poisson's ratio of the material is u and longitudinal strain is e, then the final volume of the bar becomes