For the device shown here, let all D inputs be LOW, both S inputs be HIGH, and the input be LOW. What is the status of the Y output?

Related MCQs

• For the device shown here, assume the D input is LOW, both S inputs are HIGH, and the input is HIGH. What is the status of the outputs?
• A certain BCD-to-decimal decoder has active-HIGH inputs and active- LOW outputs. Which output goes LOW when the inputs are 1001?
• The input at the 1, 2, 4, 8 inputs to a 4-line to 16-line decoder with active- low outputs is 1110. As a result, output line 7 is driven LOW.
• The XOR gate will produce a HIGH output if only one but not both of the inputs is HIGH.
• A J-K flip-flop has two control inputs. What happens to the Q output on the active edge of the clock if both control inputs are asserted simultaneously?
• The device shown here is most likely a .
• 8: A JK flip-lop has its J input connected to logic level 1 and its input to the Q output. A clock pulse is fed to its clock input. The flip-lop will now
• A J-K lip-lop has its J-input connected to logic level 1 and its input to the Q output pulse is fed to its clock input the flip-flop will now
• 9: Consider an RS lip-lops with both inputs set to 0. If a momentary '1' is applied at the input S,then the output
• An output gate is connected to four input gates; the circuit does not function. Preliminary tests with the DMM indicate that the power is applied; scope tests show that the primary input gate has a pulsing signal, while the interconnecting node has no signal. The four load gates are all on different ICs. Which instrument will best help isolate the problem?