According to IS 800, the lacing bars should resist a transverse shear equal to

Related MCQs

• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
• For a transverse load on a fillet weld of equal legs, the plane of maximum shear force occurs at
• Slenderness ratio of the lacing bar for compression member should not exceed
• If machine number is loaded in such a way that the three principla stresses at a point are 600 kg/cm2 compression. 800 kg/cm2 tension and zero. The maximum shear stress at the point will be
• If a machine member is loaded in such a way that the three principal stresses at a point are 600 kg/cm2 tension, 800 kg/cm2 compression and zero. The maximum shear stress at the point will be
• The ratio of maximum shear stress to average shear stress for a circular section is
• If the shearing stress in a nut is equal to half the tensile stress in a bolt then the length of nut should be equal to
• Gantry girders are invariably designed to resist
• Neglecting bending, for a parallel load on a fillet weld of equal legs the plane of maximum shear occurs at
• For a parallel load on a fillet weld of equal leg the plane of maximum shear occurs