For maximum horse power transmission in belt drives the velocity of belt left such that the ration tight side driving tension/centrifugal tension is

Related MCQs

• A single ply leather belt running at a belt velocity of 300 ft/min is likely to transmit per inch of width
• For water tight joints such as in boiler the rivets are driven
• In a horizontal flat belt drive for power transmission it is customary to use
• If machine number is loaded in such a way that the three principla stresses at a point are 600 kg/cm2 compression. 800 kg/cm2 tension and zero. The maximum shear stress at the point will be
• If a machine member is loaded in such a way that the three principal stresses at a point are 600 kg/cm2 tension, 800 kg/cm2 compression and zero. The maximum shear stress at the point will be
• In V-belt drive the belt touches
• Approximate horse power that can be transmitted by a shaft 60 mm diameter at 180 r.p.m. with permissible shear stress of 850 kg/cm2, would be
• A circulating water pump of a condenser is of the centrifugal type and directly connected to a three phase induction motor running at 900 rpm. The pump delivers 30,000 litres per minute against the dynamic head of 10 m. The horse power of the motor required to drive the pump would be
• The frictional horse power loss in a bearing having 25 mm diameter subjected to a load of 200 kg rotating at 600 rpm will be of the order of
• A rope sheave of balance weight for the cage is supported on an axle 25 cm. The maximum tension in the rope is 1500 kg. For safe design the point of application of the load should be considered at