For determination of allowable stress in axial compression, IS : 800-1962 has adopted

Related MCQs

• If the allowable shear stress is 960 kg/sq. cm for the size h cm, the allowable force per cm of weld length would be
• In a central heating system, the seamless copper tubing used has an inside diameter of 20 mm and a wall thickness of 0.6 mm. For a maximum pressure of 1750 Kpa, when allowable stress is 225 Mpa, the safety factor will be
• The allowable stresses for the design of steel tanks are adopted
• In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
• The approximate value of allowable stress for carbon steel under static loading (in kg/cm2) is
• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
• A spherical gas tank is made of 1 cm steel plate hemispheres but welded together. The tank is 1503 cm in diameter. The allowable internal pressure to which tank may be subjected is the permissible stress be limited to 840 kg/sq cm would be in the range
• If machine number is loaded in such a way that the three principla stresses at a point are 600 kg/cm2 compression. 800 kg/cm2 tension and zero. The maximum shear stress at the point will be
• If a machine member is loaded in such a way that the three principal stresses at a point are 600 kg/cm2 tension, 800 kg/cm2 compression and zero. The maximum shear stress at the point will be
• The basic design stress adopted for the design of light gauge steel members is