The segmental bottom of a circular tank is subjected to

Related MCQs

• A spherical gas tank is made of 1 cm steel plate hemispheres but welded together. The tank is 1503 cm in diameter. The allowable internal pressure to which tank may be subjected is the permissible stress be limited to 840 kg/sq cm would be in the range
• A locking device in which the bottom cylindrical portion is recessed to receive the tip of the locking set screw is called
• Sand drops from the bottom of a hopper into a horizontally moving belt conveyor. If the conveyor is travelling at 2000 fpm and the sand is fed at the rate of 1500 1b/min, the force necessary to drive the conveyor would be
• A foundation bolt with a circular end is secured to the floor by means of a steel cotter. If the pull on the bolt is 14000 kg, the diameter of the bolt should be
• In elevated circular steel tanks, conical bottoms are attached when
• The ratio of maximum shear stress to average shear stress for a circular section is
• For a circular section the ratio of the plastic moment capacity to the yield moment capacity is
• In elevated circular steel tanks, hemispherical bottoms are preferred because
• The ratio of the area of cross-section of a circular section and the area of its core is
• The stress concentration factor for flat bar in tension with a circular hole, is