The stress concentration factor for flat bar in tension with a circular hole, is

Related MCQs

• With a punch for which the maximum crushing stress is 4 times the maximum shearing stress of the plate, the biggest hole that can be punched in the plate would be of diameter equal to
• The ratio of maximum shear stress to average shear stress for a circular section is
• For maximum horse power transmission in belt drives the velocity of belt left such that the ration tight side driving tension/centrifugal tension is
• In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
• If machine number is loaded in such a way that the three principla stresses at a point are 600 kg/cm2 compression. 800 kg/cm2 tension and zero. The maximum shear stress at the point will be
• If a machine member is loaded in such a way that the three principal stresses at a point are 600 kg/cm2 tension, 800 kg/cm2 compression and zero. The maximum shear stress at the point will be
• A 3 mm diameter rivet must be squeezed to form a head. When yield stress in tension for this alloy is 125 Kpa, the minimum value of initiating force must be not less than
• In a standard coarse thread bolt the stress concentration is maximum at
• A unknown weight falls through 1 cm on a collar rigidly attached to the lower end of a vartical bar 3 cm long and 6 cm2 in section. If the maximum instantaneous extension is 2 mm the value of stress would be
• In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at