Full stress reversal normally does not occur in bolted connections due to

Related MCQs

• Bolted joints often fail in
• In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
• A section is subjected to reversal of stresses. Choice exists for selecting any of the following section. Which one should be selected?
• Extrafine threaded connections are generally recommended for
• In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at
• The ratio of maximum shear stress to average shear stress for a circular section is
• If the shearing stress in a nut is equal to half the tensile stress in a bolt then the length of nut should be equal to
• With a punch for which the maximum crushing stress is 4 times the maximum shearing stress of the plate, the biggest hole that can be punched in the plate would be of diameter equal to
• Belt slip may occur due to
• Large sections usually have a somewhat lower permissible stress than small sections. This is due to