Centrifugal tension in belts

Related MCQs

• Which of the following is not the advantage of V-belts over flat belts?
• For maximum horse power transmission in belt drives the velocity of belt left such that the ration tight side driving tension/centrifugal tension is
• For the same power transmission, V-belts are
• If machine number is loaded in such a way that the three principla stresses at a point are 600 kg/cm2 compression. 800 kg/cm2 tension and zero. The maximum shear stress at the point will be
• If a machine member is loaded in such a way that the three principal stresses at a point are 600 kg/cm2 tension, 800 kg/cm2 compression and zero. The maximum shear stress at the point will be
• A 3 mm diameter rivet must be squeezed to form a head. When yield stress in tension for this alloy is 125 Kpa, the minimum value of initiating force must be not less than
• For steel ultimate strength in tension compared to that in shear is
• A rope sheave of balance weight for the cage is supported on an axle 25 cm. The maximum tension in the rope is 1500 kg. For safe design the point of application of the load should be considered at
• The loss of strength in compression which occurs when there is a gain in strength in the tension due to overloading is
• The stress concentration factor for flat bar in tension with a circular hole, is