The end block of a beam has a rectangular section 100mm wide by 200mm deep, the force of cable is 200kn. Find the actual bearing pressure?

Related MCQs

• The end block of a prestressed concrete beam has a rectangular section; a cable carrying a force of 200kn is to be anchored against the end block at the centre if the cube strength of concrete at transfer is 30n/mm2. Design the maximum permissible bearing pressure?(Abr = 10000mm2)
• The bearing pressure on the concrete is given as                          
• Which type of footing is applicable when the wall carries light loads or when the safe bearing pressure is very high?
• What is the minimum number of longitudinal bars provided in the rectangular column?
• The design of rigid rectangular combined footing consist in determining the
• For a rectangular combined footing, x̅ is given as                        
• If the surface is rough tamped and without links to withstand a horizontal shear stress of 0.6n/mm2 and assuming the moduli of elasticity of precast and insitu cast concrete to be equal the centroid of the composite section is located 110mm from the top of the slab, second moment area of composite section is 2487×105mm4, calculate ultimate shearing resistance?
• In conventional design, allowable bearing capacity should be taken smaller than which of the following value?
• For initial estimate for a beam design, the width is assumed                            
• If the independent spread footing of two columns are connected by a beam, it is called