McqMate

Q. |
## For initial estimate for a beam design, the width is assumed |

A. | 1/15th of span |

B. | 1/10th of span |

C. | 1/20th of span |

D. | 1/30th of span |

Answer» D. 1/30th of span |

1.9k

0

Do you find this helpful?

11

View all MCQs in

Design of Reinforced Cement Concrete ElementsNo comments yet

- The end block of a prestressed concrete beam has a rectangular section; a cable carrying a force of 200kn is to be anchored against the end block at the centre if the cube strength of concrete at transfer is 30n/mm2. Design the maximum permissible bearing pressure?(Abr = 10000mm2)
- The various codes recommend empirical relations to estimate
- Explanation: The various codes recommend empirical relations to estimate the ultimate shear resistance of the section by considering the flexure shear and web shear cracking
- Generally combined footing is assumed to rest on
- One way slabs may be supported across the entire width of the slab by means of
- The end block of a beam has a rectangular section 100mm wide by 200mm deep, the force of cable is 200kn. Find the actual bearing pressure?
- If the independent spread footing of two columns are connected by a beam, it is called
- Which method is mainly adopted for design of steel structures as per IS code?
- The design of shear connections depends upon the strength of
- Design ultimate horizontal shear stress with nominal links and the contact surface are as cast (assume τ = 1.2n/mm2)?