The timber floor not spanning on the masonry wall but properly anchored to the wall gives

Related MCQs

• For earthquake resistant masonry buildings, the vertical distance between openings one above the other in a load bearing wall shall not be less than
• If is the height of wall between centers of supports, then the effective height of wall where concrete floors have a bearing on wall irrespective of the direction of span will be
• Direct load carrying capacity of a brick masonry wall standing freely as against when it supports RC slab will be
• For designing masonry components of a structure, seismic forces provision in the design calculation is not necessary for buildings constructed in
• Water retentivity for brick masonry should not be less than
• A free standing brick wall 20 cm thick is subjected to a wind pressure of 75kg/m². The maximum height of wall from stability consideration is
• A 200 mm thick wall made of modular bricks is 5 m long between cross walls and 3.8 m clear height between RCC slabs at top and bottom. The slenderness ratio of the wall is
• If the ratio of center to center spacing of intersecting walls to actual thickness of intersecting wall is more than 20, then the stiffening coefficient for wall proper will be
• The mode of failure of a very short masonry member having h/t ratio of less than 4 is by
• The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of