McqMate

Q. |
## A 200 mm thick wall made of modular bricks is 5 m long between cross walls and 3.8 m clear height between RCC slabs at top and bottom. The slenderness ratio of the wall is |

A. | 15 |

B. | 19 |

C. | 20 |

D. | 25 |

Answer» A. 15 |

1.6k

0

Do you find this helpful?

1

View all MCQs in

Design of Masonry StructuresNo comments yet

- If is the height of wall between centers of supports, then the effective height of wall where concrete floors have a bearing on wall irrespective of the direction of span will be
- A free standing brick wall 20 cm thick is subjected to a wind pressure of 75kg/m². The maximum height of wall from stability consideration is
- If the ratio of center to center spacing of intersecting walls to actual thickness of intersecting wall is more than 20, then the stiffening coefficient for wall proper will be
- If the horizontal cross-sectional area of a wall is 1200 cm², then the basic stress shall be multiplied by a reduction factor equal to
- The timber floor not spanning on the masonry wall but properly anchored to the wall gives
- The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of
- For strengthening a 50 m long and 5 m high straight compound wall built in brick work, which one of the following would be most suitable?
- For masonry work with solid bricks, consistency of mortar should be
- The bending stress in a wall or column subjected to effective vertical load need not be considered, if the eccentricity ratio is
- If the eccentricity ratio is more than 1/24, then increase in the permissible stress in the design of wall subjected to eccentric loading as per code is