For strengthening a 50 m long and 5 m high straight compound wall built in brick work, which one of the following would be most suitable?

Related MCQs

• A free standing brick wall 20 cm thick is subjected to a wind pressure of 75kg/m². The maximum height of wall from stability consideration is
• If is the height of wall between centers of supports, then the effective height of wall where concrete floors have a bearing on wall irrespective of the direction of span will be
• A 200 mm thick wall made of modular bricks is 5 m long between cross walls and 3.8 m clear height between RCC slabs at top and bottom. The slenderness ratio of the wall is
• Direct load carrying capacity of a brick masonry wall standing freely as against when it supports RC slab will be
• The timber floor not spanning on the masonry wall but properly anchored to the wall gives
• If the ratio of center to center spacing of intersecting walls to actual thickness of intersecting wall is more than 20, then the stiffening coefficient for wall proper will be
• Water retentivity for brick masonry should not be less than
• For earthquake resistant masonry buildings, the vertical distance between openings one above the other in a load bearing wall shall not be less than
• In a cavity wall, both leaves of which are load bearing, the effective thickness is taken as
• The bending stress in a wall or column subjected to effective vertical load need not be considered, if the eccentricity ratio is