If the eccentricity ratio is more than 1/24, then increase in the permissible stress in the design of wall subjected to eccentric loading as per code is

Related MCQs

• The bending stress in a wall or column subjected to effective vertical load need not be considered, if the eccentricity ratio is
• If the ratio of center to center spacing of intersecting walls to actual thickness of intersecting wall is more than 20, then the stiffening coefficient for wall proper will be
• If is the height of wall between centers of supports, then the effective height of wall where concrete floors have a bearing on wall irrespective of the direction of span will be
• A free standing brick wall 20 cm thick is subjected to a wind pressure of 75kg/m². The maximum height of wall from stability consideration is
• A 200 mm thick wall made of modular bricks is 5 m long between cross walls and 3.8 m clear height between RCC slabs at top and bottom. The slenderness ratio of the wall is
• If the horizontal cross-sectional area of a wall is 1200 cm², then the basic stress shall be multiplied by a reduction factor equal to
• The timber floor not spanning on the masonry wall but properly anchored to the wall gives
• For masonry built in 1 : 1 : 6 cement-lime-sand mix mortar or equivalent, the horizontal shear stress permissible on the area of a mortar bed joint is
• For earthquake resistant masonry buildings, the vertical distance between openings one above the other in a load bearing wall shall not be less than
• The thickness of each leaf of a cavity wall shall not be less than