McqMate

Q. |
## Generally the purlins are placed at the panel points so as to avoid |

A. | axial force in rafter |

B. | shear force in rafter |

C. | deflection of rafter |

D. | bending moment in rafter |

Answer» D. bending moment in rafter |

1.3k

0

Do you find this helpful?

14

View all MCQs in

Design of Steel StructuresNo comments yet

- To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be
- To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be
- The least permissible clear dimension of the web of thickness t in the panel of a plate girder, is restricted to
- The greatest permissible clear dimension of the web of thickness t in the panel of a plate girder, is restricted to
- The least permissible clear dimension of the web of thickness t in the panel of a plate girder, is restricted to
- The greatest permissible clear dimension of the web of thickness t in the panel of a plate girder, is restricted to
- The thickness of the web of a mild steel plate girder is less than d/200. If only one horizontal stiffener is used, it is placed at
- A second horizontal stiffener is always placed at the neutral axis of the girder if the thickness of the web is less than
- For double angles carrying tension, placed back to back and connected to either side of the gusset plate, the sectional area of the section, is equal to cross sectional area of
- An imaginary line along which rivets are placed, is known as