McqMate

Q. |
## The allowable tensile stress in structural mild steel plates for steel tank is assumed as |

A. | 95.0 mpa on net area |

B. | 105.5 mpa on net area |

C. | 105.5 mpa on gross area |

D. | 150.0 mpa on gross area |

Answer» B. 105.5 mpa on net area |

744

0

Do you find this helpful?

1

View all MCQs in

Design of Steel StructuresNo comments yet

- The allowable shear stress in the web of mild steel beams decreases with (Where 'h is thickness)
- The equivalent axial tensile load Pe, which produces an average axial tensile stress in the section equivalent to the combined stress due to axial tension P and bending M, at the extreme fibre of the section, is given by (where Z is the section modulus of the section).
- If fbt and fc are the co-existent bending tensile stress and shear stress in a member, the equivalent stress fc is
- The tensile strength of mild steel for bolts and nuts should not be less than
- For a steel member of slenderness ratio 350, the allowable stress is 76 kg/cm2 if it is
- For a steel member of slenderness ratio 350, the allowable stress is 76 kg/cm2 if it is
- According to IS : 800-1962 the permissible bending stress in steel slab plates, is
- When two plates are placed end to end and are joined by two cover plates, the joint is known as
- A structural member subjected to tensile force in a direction parallel to its longitudinal axis, is generally known as
- A structural member subjected to tensile force in a direction parallel to its longitudinal axis, is generally known as