- Civil Engineering
- Design of Steel Structures
- When the axis of load lies in the plane ...

Q. |
## When the axis of load lies in the plane of rivet group, then the rivets are subjected to |

A. | only shear stresses |

B. | only tensile stresses |

C. | both (a) and (b) |

D. | none of the above |

Answer» A. only shear stresses |

View all MCQs in:
Design of Steel Structures

- When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which moment in any rivet.)
- The distance measured along one rivet line from the centre of a rivet to the centre of adjoining rivet on an adjacent parallel rivet line, is called
- The distance measured along one rivet line from the centre of a rivet to the centre of adjoining rivet on an adjacent parallel rivet line, is called
- As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
- If the pitch is 6 cm and rivet value is 4 tonnes, the number of rivets required for a riveted connection carrying an eccentric load of 15 tonnes at a distance of 30 cm from the centre line, is
- Strengths of a rivet in single shearing, in bearing and in tearing are 3425 kg, 4575 kg and 5025 kg respectively. If the load in the member is 35 tonnes, the number of rivets required, is
- If the pitch is 6 cm and rivet value is 4 tonnes, the number of rivets required for a riveted connection carrying an eccentric load of 15 tonnes at a distance of 30 cm from the centre line, is
- Strengths of a rivet in single shearing, in bearing and in tearing are 3425 kg, 4575 kg and 5025 kg respectively. If the load in the member is 35 tonnes, the number of rivets required, is
- If the thickness of plate to be connected by a rivet is 16 mm, then suitable size of rivet as per Unwin's formula will be
- If the thickness of plate to be connected by a rivet is 16 mm, then suitable size of rivet as per Unwin's formula will be

Login to Continue

It will take less than 2 minutes

Report MCQ