The maximum slenderness ratio of a compression member carrying both dead and superimposed load is

Related Questions

• As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
• The maximum slenderness ratio of a compression member carrying both dead and superimposed load is
• The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is
• The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is
• If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is
• The maximum permissible slenderness ratio of a member carrying loads resulting from wind, is
• Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum slenderness ratio of each member between the connections, does not exceed
• Slenderness ratio of a compression member is
• A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed
• A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed