McqMate
Sign In
Hamberger menu
McqMate
Sign in
Sign up
Home
Forum
Search
Ask a Question
Sign In
McqMate Copyright © 2025
→
Civil Engineering
→
Design of Steel Structures
→
The number of seismic zones in which the...
Q.
The number of seismic zones in which the country has been divided is
A.
3
B.
5
C.
6
D.
7
Answer» B. 5
714
0
Do you find this helpful?
1
View all MCQs in
Design of Steel Structures
Discussion
No comments yet
Login to comment
Related MCQs
As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
As per IS : 875, for the purposes of specifying basic wind velocity, the country has been divided into
As per IS : 875, for the purposes of specifying basic wind velocity, the country has been divided into
The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is
The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is
In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the gross-diameter of the rivet is 26 mm, the number of rivets required in the splice, is
If the pitch is 6 cm and rivet value is 4 tonnes, the number of rivets required for a riveted connection carrying an eccentric load of 15 tonnes at a distance of 30 cm from the centre line, is
Number of rivets required in a joint, is
IS : 800 - 1971 recommends that in a splice plate the number of rivets carrying calculated shear stress through a packing greater than 6 mm thick, is to be increased by 2.5% for every
Strengths of a rivet in single shearing, in bearing and in tearing are 3425 kg, 4575 kg and 5025 kg respectively. If the load in the member is 35 tonnes, the number of rivets required, is